Photo album of "Straw" production for electrical work
Straws for electrical work.
Get some clothespins ready.
Something like this.
The tip should be flat.
Take the spring and break it apart.
Buy a 5 mm diameter tube that contracts when heated, used for electrical work.
Buy instant glue. Choose a plastic-only adhesive with a "primer" to dissolve the plastic and rubber. Do not buy cheap instant adhesives.
Cut the contraction tube into 4 cm pieces.
Apply primer to one side of the shrink tube and wait for 10 minutes.
Apply the primer in this way.
After 10 minutes, apply instant glue.
Apply superglue to the area, press down with clothespins, and wait for 8 hours.
Next, apply "primer" to the two ends of the clothespins.
After 10 minutes, apply instant glue to the ends of the clothespins in two places.
This is where three of them are being made at the same time. As soon as you apply the instant glue, insert the other end of the shrink tube as shown in the picture.
Wait for 8 hours for the clothespins and shrink tubing to bond well. Place a suitable weight on top.
Completion
The ends of the shrink tubing are glued together to keep the wires from poking through, so no worries!この記事が気に入ったらサポートをしてみませんか？